Description
- The unit body is made of 1mm DKP sheet metal.
- The system operates on 220V AC voltage.
- There is a 0-1 switch on the unit that provides energy to the laboratory system.
- There are illuminated switches on the unit that turn the gas and water outlets on and off.
- There is an Emergency Stop button on the unit. When the button is pressed, all units in the laboratory switch off in case of emergency.
- There is a membrane keypad on the body. There are LEDs connected to each button on the keypad that indicate active or passive status.
- The unit can be turned on and off with the power button on the membrane. AC-DC power supply and socket electricity can be turned on and off with the power supply and socket buttons.
- The unit has an AC and DC regulated 7A power supply.
- There is an “AC/DC” selection button on the power supply membrane keypad.
- The selection is shown on the information screen. The selection is also indicated by the LED on the membrane.
- The voltage on the power supply can be increased or decreased in the range of 0-15V, in 0.5V steps, with the “+” and “-” buttons on the membrane.
- The selections are shown on the information screen.
- Power supply AC and DC outputs will be short circuit protected. In case of a short circuit, the device protects itself by turning on the warning LED on the membrane.
- Additionally, this situation is shown on the information screen.
- The power supply can operate for 2 hours at full load.
- The load regulation of the power supply is maximum +- 75mV in DC.
- The power supply noise factor is more than 100mV at DC."
Reviews
Be the first to review this item
There are no reviews yet